My advice to anyone that does not have this yet ... BUY ONE! This unit makes the resin printing process very simple and easy. I have been using this for about 12 days now My suggestions for improvement: 1. Include a smaller mesh screen insert to put in bottom of wire basket. I have had several minis ruined while cleaning, small bits poke through the large holes in the basket mesh and get ground off by the impeller. This is my only complaint about the unit. 2. include a second cleaning jug (with basket, small mesh insert, etc.) so the setup has a "dirty" bath for the initial wash and a "clean" bath for second wash. How do I purchase another jug & hardware? 3. Provide guidance on how long to cure prints. I have "over cooked" a couple with too long cure time while experimenting on how long to get full cure. This is a great product! Keep up the good work! SPD
This is a great unit! Does the job and is much nicer than a janky setup, unfortunately it is annoying to listen to and it wines up and down a few times a minute. When curing it jitters, I am guessing this is how the design of the motor works but I thought I would say something as no one puts issues like these on reviews. Size your parts wash with your machine, I just bought the parts wash a week ago to pare with my peopoly moai printer and its great but now if I go to the mono x some prints may not fit... Over all these machines are worth it and make resin life a little better. PS: use plant based resin as it smells less and is a lot better to throw away. The other resins are just toxic trash.